Step 2

DISASSEMBLY-STEP 2
Disassemble in the numbered order shown in the image.




Bearing Outer Race (secondary shaft gear)
Remove the bearing outer race by lifting the funnel and the race out together.




Spring pin
For removing the selector attaching pin, match the pin's position with the removing groove, then tap the pin out with a pin punch and hammer.




Bearing Outer Race (differential, clutch housing and transaxle case)
Remove the bearing outer races with the bearing remover (49 FT01 361) and hammer. Do not remove the oil seals, unless replacement is necessary due to damage.




Bearing Outer Race (5th gear, transaxle case)
Remove both of the bearing outer races with a brass rod positioned on the race by means of the grooves in the case.

NOTE: Remove the races gradually and evenly.




Bearing Outer Race (4th gear, transaxle case)
Remove the bearing outer races gradually with the boot air out tool (49 0208 701 A) or a screwdriver with a bent end.




Oil Seal (differential)
Check the oil seals and if necessary replace them.
Use a pipe of the proper size to tap the seal out.

NOTE: Remove the oil seal gradually and evenly.