Engine, Rear Oil Seal - Prevent Damage While Assembling

91mazda01

Category
B


Applicable Model/s
1986-'90 RX-7


Subject
ENGINE REAR OIL SEAL


Bulletin No. 007/91
Issued 2/13/91
Revised


DESCRIPTION

Damaging the engine rear oil seal while assembling the flywheel (M/T) or counterweight (A/T) may cause an oil leak. The following countermeasures have been implemented since February 28, 1990 production.

a) To prevent damaging the seal, the front edge of the flywheel or counterweight has been smoothed.

b) The color of the engine rear oil seal has changed from blue to orange. Although the orange seal has a slightly higher tension, the part number has not been changed, and either seal can be used.

To prevent oil seal damage, follow the Installation Procedure shown below when replacing the oil seal.


VIN OF PRODUCTION CHANGE

JM1FC331 * L0806487 February 28, 1990
JM1FC332 * L0806487 February 28, 1990
JM1FC351 * L0806487 February 28, 1990





INSTALLATION PROCEDURE

1. Install the new oil seal to the stationary gear.





2. Using emerycloth, smooth out the indicated areas of the flywheel (M/T) or counterweight (A/T).

NOTE:

Pay particular attention that the flywheel or counterweight is centered on the eccentric shaft during assembly.


IMPORTANT:

This bulletin is a revision of Service Bulletin Category D, no. 002/90. Please reference this bulletin when using your 1990 Service Bulletin file.