Manual Transaxle 4WD

REMOVAL
Remove in the sequence shown in the image.




1. Disconnect the speedometer cable in the center.




2. Remove the bolt and clip, and remove the clutch release cylinder.




3. Disconnect the neutral switch, backup lamp switch, differential lock sensor switch, and differential lock motor connector.
4. Remove the body ground.




5. Remove the pin and cable.
6. Remove the clip and cable.




7. Mount the SST to the engine hanger.




8. Remove mount bracket No.4.
9. Remove the wheels.




10. Remove the side cover and undercover.




11. Remove the oil filter, differential lock assembly, starter and stabilizer.




12. Remove the tie-rod end and lower arm.
13. Remove the driveshaft.




14. Insert the SST to hold the side gear.




15. Remove the end plate bolts.




16. Use an engine hoist and remove the transaxle and transfer carrier.