Step 4

Disassemble in the sequence shown in the image referring to the disassembly note for the specially marked parts.

NOTE: If any of the bearings are removed, replace with new ones.

Disassembly Note
Backlash




Before disassembly, check the backlash of the side gears and pinion gears.

Standard backlash: 0-0.1 mm (0-0.004 in)

Knock-pin




To remove the knock-pin from the pinion shaft, place the gear case in a vise and knock the pin out.

NOTE: Insert the rod into the knock-pin hole from the ring gear mounting surface side.

Side bearing inner race (side opposite ring gear)




Remove the bearing inner race with the SST.

CAUTION: Hold the gear case with one hand so that it does not fall.

Side bearing inner race (ring gear side)




Remove the bearing inner race with the SST.

NOTE: Use pads in the vise.