Step 1

Disassemble in the sequence shown in the image referring to the disassembly note for the specially marked parts.

Disassembly Note
Transaxle




Mount the transaxle on the SST.

Lock nut




1. Lock the primary shaft with the SST.
2. Shift to 1st or 2nd gear.
3. Remove the lock nut.

Shift fork and shift rod assembly




1. Align the ends of the interlock sleeve and of the control lever, then turn the shift rod counter clockwise.
2. While holding the 1st-2nd shift fork with one hand and the 3rd-4th shift fork with the other, raise them both at the same time and shift each of the clutch hub sleeves.




3. Lift the control end and remove the steel ball, and, at the same time, remove the shift rod from the clutch housing.
4. Separate the shift rod and shift fork assembly from each of the clutch hub sleeves.