Inhibitor Switch

Checking Operation

1. Check that starter turns with ignition switch at Start position and selector in N and P ranges, and does not operate in other positions.
2. Check that backup light illuminates when shifted to R range with ignition switch in On position.
3. If not working as described, check continuity of switch.

Fig. 4 Inhibitor switch connector terminal identification. 1988 626 & MX-6:

Checking Continuity

1. Disconnect inhibitor switch connector.
2. Check continuity of terminals, Fig. 4, as follows:
a. With selector lever in P position, there should be continuity between terminals A and B and between terminals C and D.
b. With selector lever in R position, there should be continuity between terminals C and E.
c. With selector lever in N position, there should be continuity between terminals A and B and between terminals C and F.
d. With selector lever in D position, there should be continuity between terminals C and G.
e. With selector lever in S position, there should be continuity between terminals C and H.
f. With selector lever in L position, there should be continuity between terminals C and I.