Solenoid Valves

Fig. 9 Solenoid valves connector terminal identification. 1988 626 & MX-6:

1. Disconnect battery ground cable.
2. Disconnect solenoid valve connector.
3. Measure resistance of terminals B, C, D, E and F, Fig. 9. Resistance should be 13-27 ohms at each terminal.
4. If resistance is not correct at B terminal, replace 3-4 solenoid valve. If resistance is not correct at C or E terminal, replace 2-3 solenoid valve. If resistance is not correct at D terminal, replace lockup solenoid valve. If resistance is not correct at F terminal, replace 1-2 solenoid valve.