Rear Rotor Housing

Fig. 5 Removing Tubular Dowel:

Fig. 6 Removing Rear Rotor Housing:

1. Remove the two sealing rubbers and O-ring from the rear side of the rear rotor housing.
2. Attach the puller (49 0813 215A), and pull the tubular dowels off the rear rotor housing while holding the rotor housing down by hand to prevent it from moving up, Fig. 5.
3. Lift the rear rotor housing away from the rotor, Fig. 6, being careful not to drop the apex seals on the rear rotor. Remove the two sealing rubbers and O-ring from the front side of the rear rotor housing. Discard the used sealing rubbers and O-ring, then use new sealing rubbers and O-ring.