Engine, Rear Oil Seal - Revised to Prevent Oil Leak

90mazda03
Category Applicable Model/s

D 1986-'90 RX-7

Subject ENGINE REAR OIL SEAL

Bulletin No. 002/90
Issued 7/6/90
Revised

DESCRIPTON

Damaging the engine rear oil seal while assembling the flywheel (M/T) or counterweight (A/T) may cause an oil leak. The following countermeasures have been implemented since February 28, 1990 production.

a) To prevent damaging the seal, the front edge of the flywheel or counterweight has been smoothed.

b) The color of the engine rear oil seal has changed from blue to orange. Although the orange seal has a slightly higher tension, the part number has not been changed, and either seal can be used.

To prevent oil seal damage, follow the installation procedure shown below when replacing the oil seal.


VIN OF PRODUCTION CHANGE


JM1FC331} LO806487 February 28, 1990 JM1FC332} LO806487 February 28, 1990 JM1FC351} LO806487 February 28, 1990




INSTALLATION PROCEDURE


1. Install the new oil seal to the stationary gear.



2. Using emerycloth, smooth out the indicated areas of the flywheel (M/T) or counterweight (A/T).

NOTE:
Pay particular attention that the flywheel or counterweight is centered on the eccentric shaft during assembly.