All Wheel Drive

Fig. 24 Power Steering Gear Replacement:

Fig. 25 Engine Mount Member Replacement:

Fig. 26 Engine Mount No. 4 Bolt Replacement:

1. Raise and support front of vehicle, then remove wheels.
2. Remove battery and battery tray, then the undercover.
3. Remove steering gear in numbered sequence, Fig. 24, noting the following:
a. Before removing crossmember, install engine holding fixture No. 49G0175A0 or equivalent.
b. Remove No. 1 and No. 2 engine mount nuts, then the engine mount member, Fig. 25.
c. Remove No. 4 engine mount nuts, Fig. 26.
d. Remove front exhaust pipe and catalytic converter as an assembly.
e. Disconnect propeller shaft.
f. Lower engine slightly until lower left mounting bolt can be removed. Do not lower engine too much as damage to front left driveshaft bolt may occur.
g. Remove lower left mounting bolt.
h. Remove steering gear from left side of vehicle.
4. Install steering gear reversing numbered sequence, Fig. 24.