Fuel and Intake Air System

Fuel Devices




1. Fuel tank
2. Fuel pump
3. Fuel filter (High-pressure)
4. Pressure regulator
5. Pulsation damper
6. Injector
7. Separator
8. Two-way check valve
9. Check-and-cut valve
10. Cold start injector
11. Cold start injector switch
12. Charcoal canister

Fuel And Intake System Components:

Fig. 1

Fuel Tank Components:

Fig. 2

Shutter Valve And Actuator:

Fig. 3


BYPASS AIR CONTROL (BAC) VALVE
Mounted on the dynamic chamber, just in front of the throttle body (fig. 1).

CHECK AND CUT VALVE
Behind the cover panel, on the right side of the trunk compartment (fig. 2).

COLD START INJECTOR
Installed in the top of the throttle body (fig. 1).

COLD START THERMOSWITCH
Installed at the water outlet on the front of the intake manifold (fig. 1).

FUEL FILTER
In the right front of the engine compartment, at the rear of the alternator (fig. 1).

FUEL INJECTORS
Installed in the intake manifold, where the manifold meets the cylinder head, beneath the dynamic chamber. Injectors are held in place by the fuel rail (fig. 1).

FUEL PRESSURE REGULATOR
Mounted on the fuel block on the fuel rail, right rear corner (fig. 1).

FUEL PUMP
Installed on the top of the fuel tank (fig. 2).

FUEL PUMP RELAY (CIRCUIT OPEN RELAY)
Behind the drivers side left kick panel, under the dash (fig. 1).

FUEL RAIL (DELIVERY PIPE)
Mounted on the intake manifold, beneath the dynamic chamber (fig. 1).

FUEL TANK
Under the rear of the vehicle, held in place by metal straps (fig. 2).

PULSATION DAMPER
Mounted on the fuel block at the right rear corner of the fuel rail (fig. 1).

SHUTTER VALVE (VARIABLE RESONANCE INDUCTION SYSTEM - VRIS)
Installed in the dynamic chamber, just inside from the throttle body. Valve installs from underneath (fig. 3).

SHUTTER VALVE ACTUATOR
Mounted on the dynamic chamber, just behind the throttle body (fig. 3).

THROTTLE BODY
Mounted on the dynamic chamber at the air inlet (fig. 1).