Distributor: Service and Repair

DISTRIBUTOR

Distributor Replacement:

REMOVAL

1. Remove high tension leads.
2. Disconnect wiring harness.
3. Turn crankshaft to #1 cylinder TDC.
4. Remove mounting bolt and lift off distributor. Do not turn engine while distributor is removed.

INSTALLATION

Install in the reverse order of removal and note the following:

1. Coat the O-ring with engine oil.
2. Ensure that #1 cylinder is at TDC.
3. Align distributor drive blade with slot in camshaft.
4. After installation, adjust ignition timing. Refer to ADJUSTMENT PROCEDURES.
5. Tighten mounting bolt to 14 - 19 ftlb (19 - 25 Nm).