Intermediate Housing

Fig. 35 Sealer Application Areas:

1. Apply petroleum jelly to new outer and inner sealing rubber.
2. Install outer sealing rubber to the front side so that the white paint faces the side wall in the groove.
3. Install inner sealing rubber to front side so that blue paint faces outer wall in groove and that seam is properly positioned.
4. Ensure outer and inner sealing rubbers are not twisted.
5. Apply engine oil to contact surfaces of intermediate housing. Do not apply engine oil to sealing rubber.
6. Apply engine oil to rotor oil seal on rear side of front rotor.
7. Apply petroleum jelly to new O-ring and install O-ring on rotor housing.
8. Apply a coat of suitable sealant as shown, Fig. 35.
9. Turn eccentric shaft so that rear rotor journal faces the intake and exhaust side.
10. Pull the eccentric shaft about 1 in. (25mm), but do not pull over 1.5 in. (35mm).
11. Install the intermediate housing through the eccentric shaft on the front rotor housing.