Bearing Housing

Assemble in the order shown in the image, referring to Assembly Note.




Assembly note
Countershaft center bearing
1. Press the countershaft center bearing into the bearing housing with a suitable pipe.




2. Measure the clearance between the countershaft center bearing and the bearing housing.
If the clearance is not within the standard, adjust it by using an adjustment shim(s).

Standard clearance: 0 - 0.1 mm (0 - 0.004 in)
Adjustment shim: 0.1 mm (0.004 in), 0.3 mm (0.012 in)




Mainshaft front bearing
1. Press the mainshaft front bearing into the bearing housing with a suitable pipe.




2. Measure the clearance between the mainshaft front bearing and the bearing housing.
If the clearance is not within the standard, adjust it by using an adjustment shim(s).

Standard clearance: 0 - 0.1 mm (0-0.004 in)
Adjustment shim: 0.1 mm (0.004 in), 0.15 mm (0.006 in), 0.3 mm (0.012 in)




Bearing cover
1. Install the reverse idler gear.

Tightening torque: 7.8 - 11 N-m (80 - 110 cm-kg, 69 - 95 in)




2. Install the 2 washers, reverse idler gear, and bearing cover.

Tightening torque:
(A): 16 - 23 N-m (1.6 - 2.3 m-kg, 12 - 17 ft-lb)
(B): 36 - 54 N-m (3.7 - 5.5 m-kg, 27 - 40 ft-lb)