Disassembly/Assembly
DISASSEMBLYWheel Hub
1. Loosen the dust cover.
2. Press the wheel hub with the SST to remove it.
3. Remove the sensor rotor (ABS).
Wheel Bearing
1. Press the wheel hub with the SST and remove the wheel bearing inner race.
2. Remove the retaining ring from the toe control hub using snap ring pliers.
3. Remove the wheel bearing outer race with the SST.
Hub Bolt
Caution:
a) Do not remove the hub bolts unless necessary.
b) Do not reuse the hub bolts.
Replace the hub bolts using a press, if necessary.
ASSEMBLY
Hub Bolt
Install the new hub bolts with a press.
Wheel Bearing
1. Press the wheel bearing into the toe control hub with the SST.
2. Install the retaining ring using snap-ring pliers.
3. Install the dust cover.
Tightening torque: 16-23 Nm (1.6-2.3 m-kg, 12-17 ft-lb)
4. Install the sensor rotor (ABS).
Wheel Hub
1. Press the wheel hub in with the SST.