With Disc Brakes

REMOVAL





Remove in the order shown in the figure.

DISASSEMBLY





Note:
Do not remove the hub bolts unless necessary.
Do not reuse the hub bolts if removed.

Sensor Rotor (ABS)





Remove the sensor rotor with the SST.

Note:
Do not remove the sensor rotor unless necessary.
Do not reuse the sensor rotor If removed.

Rear Wheel Bearing





Remove the rear wheel bearing with the SST.

Note:
Do not reuse the rear wheel bearing If removed.

INSPECTION





Check as described below, replace parts if necessary.

1. Check the hub for cracks or damage.





2. heck the sensor rotor for cracks or damage.





3. Check the knuckle spindle for cracks or damage, and the oil seal friction surface for wear or rust.





4. Check the dust cover for damage.
5. Check the hub cap for damage.

ASSEMBLY





1. Install new hub bolts.





2. Install a new sensor rotor with the SST. (ABS)





3. Install a new rear wheel bearing with the SST.
4. Install the retaining ring.





5. Install a new oil seal with the SST.

Note: Apply grease to the oil seal lip.

INSTALLATION





1. Install in the reverse order of removal as shown in the figure.

Caution: Loosely tighten the knuckle and the lateral links when installing. Lower the vehicle and tighten nuts and bolts to the specified torques with the vehicle unladen.
2. After installation, adjust the parking brake lever stroke.
3. Inspect rear wheel alignment and adjust it as necessary.

End Play





Measure the end play.

Maximum end play: 0.2 mm (0.0079 in)