Rear Wheel Speed Sensor & Rotor
REAR WHEEL SPEED SENSOR AND SENSOR ROTORRemoval / Installation
1. Remove in the sequence shown in the figure, referring to the Removal Note.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal, referring to the Installation Note.
4. Tighten all nuts and bolts to the specified torques, referring to the figure.
Removal Note
Speed sensor
1. Remove the bolts, then remove the wheel speed sensor from the hub.
Sensor rotor
1. Remove the driveshaft.
2. Remove the sensor rotor from the driveshaft with a chisel.
Installation Note
Speed sensor
1. Install the wheel-speed sensor and tighten the attaching bolt.
Tightening torque: 16 - 23 Nm (1.6 - 2.3 m.kg, 12 - 17 ft.lb)
Sensor rotor
1. Remove the boot band and slide the boot.
2. Set the SST on the press as shown in the figure.
3. Press the sensor rotor onto the driveshaft with the SST.