Fuel Delivery and Air Induction: Locations

Bypass Air Control (BAC) Valve:

Fig. 1

Fuel Delivery Components:

Fig. 2

Intake Air System:

Fig. 3

Fuel Pressure Regulator And Pulsation Damper:

Fig. 4

BYPASS AIR CONTROL (BAC) VALVE
Mounted on the front of the left valve cover (fig. 1).

CHECK AND CUT VALVE
Behind the cover panel on the right side of the trunk compartment (fig. 2).

DASHPOT
Mounted on the throttle body (fig. 3)

FUEL FILTER
Near the front of the right side valve cover (fig. 2).

FUEL INJECTORS
Installed in the intake manifold, where the manifold and cylinder heads join. Injectors are held in place by the fuel rails. Entire assembly is beneath the dynamic chamber and extension manifolds (fig. 2).

FUEL PRESSURE REGULATOR
Mounted on a bracket at the rear of the right side valve cover, along with the pulsation damper (fig. 4).

FUEL PUMP
Installed in the top of the fuel tank, integral with the fuel gauge sending unit (fig. 2).

FUEL PUMP RELAY (CIRCUIT OPEN RELAY)
Behind the drivers side kick panel, under the dash (fig. 2).

FUEL RAIL
Mounted on the intake manifold, beneath the dynamic chamber and extension manifolds (fig. 2).

FUEL TANK
Under the rear of the vehicle, held in place by metal straps (fig. 2).

PULSATION DAMPER
Mounted on a bracket at the rear of the right side valve cover, along with the fuel pressure regulator (fig. 4).

SHUTTER VALVE (VARIABLE RESONANCE INDUCTION SYSTEM - VRIS)
Installed in the front of the dynamic chamber (fig. 3).

SHUTTER VALVE ACTUATOR (VARIABLE RESONANCE INDUCTION SYSTEM - VRIS)
Mounted on the front of the dynamic chamber, concealed by a cover box (fig. 3).

SWIRL CONTROL VALVES (TRIPLE INDUCTION CONTROL SYSTEM - TICS)
Installed in the intake manifold, just above where the manifold meets the cylinder heads (fig. 3). These valves are manufactured as part of the intake manifold, and, according to the manufacturer, are not serviceable

SWIRL CONTROL VALVE ACTUATOR (TRIPLE INDUCTION CONTROL SYSTEM - TICS)
Mounted on the left front of the intake manifold (fig. 3).

THROTTLE BODY
Mounted on the inlet side of the intake air pipe to the dynamic chamber (fig. 3).