Suspension - Excessive Negative Rear Camber

Bulletin No.: 005/93
Issued: 7/7/93
Revised:

Applicable Model/s
1988-91 929

Subject
REAR CAMBER ADJUSTMENT

APPLICABLE MODELS/VINS
929 MODELS

1988 - Vehicles with a VIN of JM1HC22**J0100001 through JM1HC22**J0199999

1989 - Vehicles with a VIN of JM1HC22**K0200001 through JM1HC22**K0299999

1990 - Vehicles with a VIN of JM1HC22**L0300001 through JM1HC22**L0399999

1991 - Vehicles with a VIN of JM1HC22**M0400001 through JM1HC22**M0499999

DESCRIPTION

Vehicles with noticeably excessive negative camber may require upper control link replacement. A modified control link has been established for these vehicles. The link is longer and increases camber by .3 degrees.

REPLACEMENT PROCEDURE





Vehicles with excessive negative camber should have the control link replaced with the modified part. Refer to section "R" of the applicable workshop manual for removal and installation procedures. The Parts Information section of this bulletin provides information on parts ordering.





PARTS INFORMATION

WARRANTY INFORMATION
(Applies to vehicles covered under warranty)

Warranty Type Code: A
Customer Comment Code: 87
Damage Code: 9E
Part No. of Main Cause: See Parts Information
Operation No.: R0506CRX (One Side)
R0506DRX (Both Sides)
Labor Hours: 0.4 Hrs. (One Side)
0.6 Hrs. (Both Sides)

NOTE:
The operation numbers above include rearwheel alignment. Front wheel alignment is not covered.