Installation
1. Raise the vehicle and support it with safety stands.
2. Install in the order shown in the image, referring to Installation Note.
3. Add the specified amount of the specified transmission oil.
4. Warm up the engine and transmission, and inspect for oil leakage and transmission operation.
Installation note
Transmission
Tilt the engine by pushing up on the front of oil pan with a wooden block and a jack for easy installation of the transmission.
Power plant frame (PPF)
1. Install the differential mounting spacer.
Tightening torque: 37 - 52 N-m (3.8 - 5.3 m-kg, 27 - 38 ft-lb)
2. Support the transmission with a jack so that it is level.
3. Position the PPF and snugly tighten the transmission-side bolts by hand.
4. Verify that the sleeve is installed into the block.
NOTE: The reamer bolt is installed in the forward hole.
5. Install the spacer and bolts, then snugly tighten them.
6. Snugly install the power plant frame bracket.
7. Tighten the transmission-side bolts.
Tightening torque: 104 - 124 N-m (10.6 - 12.6 m-kg, 77 - 91 ft-lb)
8. Tighten the differential-side bolts.
Tightening torque: 104 - 124 N-m (10.6 - 12.6 m-kg, 77 - 91 ft-lb)
9. Install the power plant frame bracket.
Tightening torque:
(A): 104 - 123 N-m (10.6 - 12.6 m-kg, 77 - 91 ft-lb)
(B): 36 - 54 N-m (3.7 - 5.5 m-kg, 27 - 40 ft-lb)
10. Remove the jack, and connect the wire harness.
11. Measure distance A with a straightedge and vernier calipers.
Distance A: 66.0 ± 5 mm (2.60 ± 0.197 in)
12. If the distance is not within specification, reposition the PPF at the transmission.
Propeller shaft
Align the marks, and install the propeller shaft.
Tightening torque: 27 - 30 N-m (2.8 - 3.1 m-kg, 20 - 22 ft-lb)
Shift lever
NOTE: Add the specified oil whenever the extension housing has been removed or the transmission has been overhauled.
1. Pour the specified amount of oil into the change control case.
Specified oil:
Grade: API service GL-4 or GL-5
All season: SAE 75W - 90
Above 10 °C (50 °F): SAE 80W - 90
Specified amount: 80 - 95 cc (4.9 - 5.8 cu in)
2. Apply oil to the shift lever as shown.
3. Apply sealant to the contact surfaces of the boot panel and change control case.