Memory Cancel

MEMORY CANCEL

Note: Failures are contained in the control unit memory. They are not erased when the battery is disconnected. Follow the procedure below to erase them.





1. Connect terminal-wires (G/R) and (G/B) of the check connector (at the control unit) with a jumper wire.
2. Turn the ignition switch ON.
3. Check that the warning lamp illuminates, and wait 1-2 seconds.
4. Turn the ignition switch OFF.





5. Disconnect the jumper wire from terminal-wire (G/R).
6. Start the engine and wait for the warning lamp to go OFF.

Note:
^ One failure memory is erased each time the above steps are taken.
^ If the warning lamp illuminates or flashes after step 6, read and note the diagnosis indication. The memory has the capacity for storing 32 failures.

7. Turn the ignition switch OFF.
8. Remove the jumper wire.