Area A: Kick Panel

1. Follow the same repair procedure described for the right front side of the passenger compartment.

2. Run water on the antenna. Make sure the antenna tube is intact on the bottom of the power antenna motor and water drains properly (for models equipped with power antenna.)

3. If necessary, position the hose so there are no loops, kinks or pinched areas. If the hose cannot be corrected or is out, remove the damaged section of hose. Install a replacement piece of hose (4.7 mm [3/16 in.] outside diameter) which provides a tight fit to the existing hose.





4. If the leak persists, inspect the antenna bezel molding and gasket for correct sealing and mounting. Confirm that the mounting screw is fully seated and that the gasket is firmly contacting the roof sheet metal. Figure 13.