Condition A

Condition A: Wind noise at front door area during high speed (above 40 mph) driving





LOCATION 1 (DOOR MIRRORS)(ALL MODELS/YEARS)

Manual and Power Mirrors

1. Using a flat screwdriver, carefully pry the inner sail garnish out of its position. (Start prying at the top comer of the sail garnish then work downward.)

CAUTION:
TAKE CARE NOT TO BREAK THE FASTENING TAB AT THE BOTTOM OF THE SAIL GARNISH.

2. Remove mirror and install comer bracket.





3. Install Pad 1 on the side of the base. Figure 1.

4. Install Pad 2 on lower side of base. Figure 1.

5. Install Pad 3 (triangular pad) as shown. Figure 1.

Power Mirrors Only





6. Add respective (right and left) seal rubber to the mirror. Figure 2.

Manual Mirrors Only





7. Add respective (right and left) seal rubber to the mirror base. Figure 3.

Manual and Power Mirrors

8. Reinstall mirror.

LOCATION 2 (GLASS INNER WEATHERSTRIP-ALL DOORS)(1988-'89 MODELS ONLY)

1. Lower window all the way.

2. Remove door trim.





3. Replace glass inner weatherstrip with new strip. Figure 4.

LOCATION 3 (GLASS RUN CHANNEL-FRONT DOOR)(1988-'89 MODELS ONLY)

1. Lower window all the way.





2. Pull back the glass run channel. Figure 5.

3. Attach the pad strip to the back of the glass run channel from the circled area.

Pad size:

Length - 400 mm
Thickness - 2 mm
Width - 10 mm

LOCATION 4 (GLASS GUIDE RAIL)(ALL MODELS/YEARS)





1. Remove the 3 screws which secure the glass guide rail and remove the door inner trim panel. Figure 6.





2. Lower the window glass to about 4" showing. Pull the glass guide rail toward the inside of the window frame and up. Move the window glass toward the front of the vehicle. Figure 7.





3. Remove the original glass guide rail pad and replace it with a new one. Figure 8.





A) Install the new glass guide rail pad so that the top of the pad is 30 mm from the bottom of the guide rail. Figure 9.

B) The remaining length of the pad (10 mm) should be pinched so that the sides stick together. Figure 9.

4. Reinstall the glass guide rail and door inner trim panel.

CAUTION:
For ease of installation, door glass must be up approximately 4 inches.

LOCATION 5 ("A" PILLAR AREA)(1988-'89)

4 and 5-door models





1. Open the front door and remove the mounting screw from the lower side of the drip molding. Figure 10.

2. Remove the original screw boss from the pillar and discard.





3. Install a protector between the drip molding and the "A" pillar. Figure 11.





4. Reinstall the mounting screw and insert the protector inside the front fender cavity. Figure 12.

MX-6





1. Cut the boss off of the protector. Figure 13.





2. Glue the protector to the drip molding. Figure 14.

3. Insert protector into fender cavity. Figure 14.