Flywheel

1. Turn the engine so that the top of the engine is up.
2. Apply engine oil to the oil seal in the rear housing.
3. Fit the key into keyway on the eccentric shaft.
4. Install the flywheel to the rear end of the eccentric shaft, aligning the keyway of the flywheel with the key.
5. Apply sealing agent to both sides of the flywheel lock washer and place it in position. Install the nut.
6. Install the suitable flywheel brake and with the box wrench (49 0820 035) tighten the nut to 290-360 ft. lbs.
7. Bend the tab of the lockwasher.