Rear Housing

Fig. 35 Sealer Application Areas:

1. Apply engine oil to new rear oil seal and the groove of the rear stationary gear.
2. Install oil seal into rear stationary gear.
3. Install oil regulator valve, torquing to specification.
4. Apply petroleum jelly to new outer and inner sealing rubbers.
5. Install outer sealing rubber so that white paint faces side wall in groove.
6. Install inner sealing rubber so that blue paint faces outer wall in groove and seam is properly positioned.
7. Ensure inner and outer sealing rubbers are not twisted.
8. Apply sufficient engine oil onto the contact surfaces, stationary gear and main bearing. Do not apply engine oil to sealing rubber.
9. Apply engine oil to rotor oil seal of rear rotor's rear side.
10. Apply petroleum jelly to new O-ring and install O-ring in rear housing.
11. Apply coat of suitable sealant as shown, Fig. 35.
12. Install the rear housing on the rear rotor housing. Ensure side pieces of front and rear apex seals are not wedged between rotor housing and side housing.