Installation

INSTALLATION

Hub Nut





Install the hub nut and adjust the bearing preload.
1. Tighten the nut and then turn the hub and plate 2 or 3 times to seat the bearing.

Tightening torque:
20-29 Nm (2.0-3.0 m-kg, 14-22 ft-lb)

2. Loosen the nut until it can be turned by hand.





3. Attach a pull scale to a hub bolt and measure the frictional force.
4. Tighten the locknut until the reading (initial turning torque.) reaches the specified amount. Then insert the set cover, and secure with a new cotter pin.

Preload:
Frictional Force Plus 3.9-9.8 N (0.4-1.0 kg, 0.9-2.2 lb)

Speed Sensor





Install the speed sensor, and check the clearance between the sensor rotor and speed sensor.

Standard Clearance: 0.4-1.0 mm (0.016-0.039 in)