Fuel Delivery and Air Induction: Locations

Intake Air System:

Fig. 1

Fuel Delivery Components:

Fig. 2

Fuel Tank Assembly:

Fig. 3

Fuel And Emission Components:

Fig. 4

Throttle Body And Dynamic Chamber (W/Manual Trans):

Fig. 5

Throttle Body And Dynamic Chamber (W/Auto Trans):

Fig. 6


AUXILIARY PORT VALVES
Installed in the front and rear rotor housings, wth the actuator rod extending through the front and rear secondary intake manifold ports (fig. 1).

AUXILIARY PORT VALVE ACTUATOR
Mounted on the lower front and rear of the intake manifold (fig. 1).


BYPASS AIR CONTROL VALVE
Mounted on the extension manifold, below the throttle body (fig. 1).

CHECK AND CUT VALVE
Mounted just in front and above the fuel tank, access from under the vehicle (fig. 3).

DASHPOT
Installed on the throttle body (fig. 5 &/or 6).

DOUBLE THROTTLE DIAPHRAGM (W/AUTO TRANS ONLY)
mounted on the throttle body (fig. 6).

FUEL FILTER
In the rear of the engine compartment, left (drivers) side (fig. 2).

FUEL INJECTORS
Primary - installed in the right side of the engine rotor housings, below the extension manifold, held in place by the primary fuel rail (fig. 1 & 2).

Secondary - Installed in the intake manifold, on either side of the BAC valve, held in place by the secondary fuel rail (fig. 1 & 2).


FUEL PRESSURE REGULATOR
Built into the front end of the secondary fuel rail (fig. 2).

FUEL PUMP
Installed in top of the fuel tank, as part of the fuel gauge sensor unit (fig. 3).

FUEL PUMP RELAY (CIRCUIT OPEN RELAY)
Mounted on the right side of the steering collumn, inside the steering collumn cover (fig. 4).

FUEL PUMP RESISTOR RELAY
In the right front fof the engine compartment, just in front of the air cleaner box (fig. 4).

FUEL RAILS (DELIVERY PIPES)
Primary - mounted on the engine rotor housing, beneath the dynamic chamber (fig. 1 & 2).

Secondary - mounted on the intake manifold, at the junction of the manifold to the dynamic chamber (fig. 1 & 2).

FUEL TANK
Mounted under the vehicle, just in front of the rear sub-frame. Held in place by metal straps (fig 3).

VDI VALVE
Installed in the "exten" manifold, beneath the dynamic chamber (fig. 1).

VDI VALVE ACTUATOR
Mounted on the "exten" manifold, just below the dynamic chamber (fig. 1).

PULSATION DAMPER
Built into one end of the primary fuel rail (fig. 1 & 2).

SECONDARY THROTTLE VALVE DIAPHRAGM
Mounted on the throttle body (fig. 5).

THROTTLE BODY
Mounted on the right side (inlet side) of the dynamic chamber, above the "exten" manifold (fig. 1 & 5).

WATER THERMOVALVE (W/AUTO TRANS)
Mounted on the throttle body (fig. 6).

WATER THERMOVALVE (W/MANUAL TRANS)
Mounted on the throttle body (fig. 5).