Selector Shaft: Adjustments

Fig. 3 Selector Lever Adjustment:

1. Move gearshift lever to ``P'' position.
2. Loosen locknuts ``A'' and ``B,'' Fig. 3.
3. Shift transmission to ``P'' position by moving selector lever on transmission.
4. Using a feeler gauge, adjust gap between adjust lever and locknut ``A'' to .039 inch (1 mm), then remove gauge and torque locknuts to 69-95 inch lbs.
5. Move selector lever to ``N,'' ``D'' and ``P'' ranges and ensure there is clearance between select lever bracket and guide pin.
6. If clearance is not satisfactory, readjust locknuts.