One-Way Clutch 2 Carrier Hub Assembly

Disassembly / Inspection / Assembly
1. Disassemble in the order shown in the figure.
2. Inspect all parts and repair or replace as necessary.
3. Assemble in the reverse order of disassembly, referring to Assembly Procedure.

Inspection




One-way clutch 2
Check for the following and repair or replace as necessary.

NOTE: Assemble the one-way clutch and the inner race, then verify that the one-way clutch rotates only clockwise and smoothly.

1. Damaged or worn one-way clutch and operation.
2. Detached roller.




Carrier hub assembly
Check for the following and repair or replace as necessary.
1. Damaged or worn gear and operation.
2. Clearance between pinion washers and planetary carrier.

Clearance: 0.2 - 0.7 mm {0.008 - 0.028 in}

Assembly procedure




1. Assemble the carrier hub assembly to the inner race.




2. Install the snap ring.

NOTE: Install the tangs of the bearing race into the alignment holes.




3. Apply petroleum jelly to the bearing race and secure them to each side of the one-way clutch 2 and carrier hub assembly.

Bearing race outer diameter
Sun gear drum side: 84.0 mm {3.307 in}