A/T - Throttle Cable Won't Move After Rebuild Install

Bulletin No.: 001/93
Issued: 2/12/93
Revised

Category
K

Applicable Model/s
See Below

Subject:
THROTTLE CABLE WILL NOT MOVE AFFER INSTALLING REBUILT A/T

NOTE:
This bulletin supercedes Service Bulletin # 020/92, Cat. K, issued 12/15/92.

APPLICABLE MODELS

1990-92 323 1990-92 Protege 1992 MX-3

DESCRIPTION

On rebuilt A/T units, a pin is used for holding the throttle cam in place to make installation of the control valve easier. If a rebuilt A/T is installed without removing the pin, the throttle lever will remain in a fixed position and the throttle cable will not move.

REPAIR PROCEDURE

1. When installing a rebuilt A/T, be sure to remove the throttle cam pin (Pin A).





2. Also, remove the throttle cam bolt (Bolt B) from the original A/T (unit that is being replaced) and reinstall into the throttle cam of the replacement rebuilt A/T. If needed, this bolt may be ordered separately, under part number FU61 19 423. Bolt B is an allen screw, socket head bolt. See illustration.

When installing the bolt, apply sealant to prevent oil leakage.

NOTE:
Inspect and adjust the throttle cable after installing the rebuilt A/T as outlined in Section K of the applicable Workshop Manual.

PARTS INFORMATION





The affected rebuilt A/Ts are listed: (see illustration)