Receiver Dryer: Service and Repair
Removal1. Discharge the refrigeration system.
2. Remove the radiator grill.
3. Disconnect the pipes from the receiver/drier.
NOTE: Immediately plug the open fittings to keep moisture out of the system.
4. Remove the receiver/drier from the bracket.
Installation
1. Install the~receiver/drier onto the bracket.
2. Connect the pipes to the receiver/drier.
Tightening torque: 15 - 25 N.m (1.5 - 2.5 m-kg, 11 - 18 ft-lb)
4. If the receiver/drier is replaced, add compressor oil to the compressor.
Compressor Oil: 10 cc (0.61 cu in)
5. Install the radiator grille.
6. Evacuate, charge, and test the refrigeration system.