Distributor: Service and Repair

Removing/Installing Distributor:

Distributor Cap And Rotor:

REMOVAL

1. Remove ignition wires from the distributor cap.
2. Remove the distributor cap .
3. Disconnect wiring harness.
4. Turn crankshaft to #1 cylinder TDC and note the position of the rotor.
5. Remove mounting bolt and lift off distributor. Do not turn engine while distributor is removed.

INSTALLATION

Install in the reverse order of removal and note the following:

1. Coat the O-ring with engine oil and coupling shaft with grease.
2. Ensure that #1 cylinder is at TDC.
3. Install distributor with rotor pointing in the same direction as it was during removal.
4. After installation, adjust ignition timing (see Adjustments).
5. Tighten mounting bolt to 14 - 19 ft lb (19 - 25 Nm).