Interior - Glove Box Rattles
S024/92INSTRUMENT PANEL RATTLES IN GLOVE BOX
AREA
APPLICABLE MODELS
1992 MX-3
DESCRIPTION
A rattling noise may be heard when the vehicle is in motion and the glove box door is open. This may be due to the positioning of a speed nut that secures the lower panel pulling through the pad.
Production changes have been made since October 8, 1991 to correct this problem. If this problem exists on vehicles produced prior to October 8, 1991, install a new speed nut using the Repair Procedure described in this bulletin and the Workshop Manual, Section S.
VIN OF PRODUCTION CHANGE
JM1EC4302N0107107 October 8, 1991
REPAIR PROCEDURE
1. Remove the lower panel and the old speed nut according to Workshop Manual procedures, Section S. Figure 1.
NOTE:
Only a part of the U-type speed nut is required to grip the flange as shown in Figure 2.
2. Install new U-type speed nut and reinstall lower panel. Figure 3.
PARTS INFORMATION
WARRANTY INFORMATION
(applies to vehicles covered under warranty)
Warranty Type Code
A
Customer Comment Code
92
Damage Code
97
Part No. of Main Cause
H260 50 049
Operation No
XX0449RX
Labor Hours
0.2
Disclaimer