Shift Mechanism

1. Disassemble in the order shown in the image.
2. Inspect all parts and repair or replace as necessary.
3. Assemble in the reverse order of disassembly, referring to Assembly Note.




1. Transverse member
2. Exhaust pipe
3. Shift lever knob
4. Rear ashtray
5. Rear console
6. Front console
7. Nut
8. Bolt
9. Nut
10. Bolt
11. Bushing
12. Change control rod Inspect for bending
13. Nut
14. Washer
15. Pipe
16. Bushing
17. Washer
18. Bushing
19. Nuts
20. Washers
21. insulator
22. Mounting rubber boot
23. Spring
24. Ball seat (upper)
25. Gear shift lever
26. Boot
27. Holder
28. Ball seat (lower)
29. Extension bar




Assembly Note
Extension Bar
1. Install the extension bar to the floor, and then onto the transaxle.

Tightening torque: 37-52 N.m (3.8-5.3 m-kg, 27-38 ft-lb)

2. Tighten the bracket installation nuts to the specified torque.

Tightening torque: 9.8-15 N.m (1.0-1.5 m-kg, 7.2-11 ft-lb)




Spring
Make sure that the hooked part of the spring is properly seated in the bracket groove, as shown in the image.