Mounting

MOUNTING





1. Use the holes shown in the figure.





2. Install the SST (arms) to the holes as shown in the figure, and hand tighten the SST (bolts).





3. Assemble the SST (bolts, nuts, and plate) in the specified positions marked A, E, and I.





4. Install the SST assembled in step 3 to the respective arms.
5. Adjust the SST (bolts) so that less than 20 mm (0.79 in) of thread is exposed.
6. Make the SST (plate and arms) parallel by adjusting the SST (bolts and nuts).
7. Tighten the SST (bolts and nuts) to affix the SST firmly.





8. Mount the engine on the SST (engine stand).