2WD
REMOVALFig. 2 Rear Axle Replacement:
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Using a steel plate and the SST, press the rotor on until it is flush with the wheel hub.
INSTALLATION
Locknut
1. Install a new locknut and stake it, as shown
Tightening torque: 177-235 Nm (18-24 m-kg, 130-174 ft-lb)
DISASSEMBLY
Caution:
- Do not remove the hub bolts if not necessary.
- Do not reuse the hub bolts if removed.
1. Remove the hub bolts with a press.
ASSEMBLY
Hub Bolt
1. Press in new hub bolts.