Output Gear
OUTPUT GEARPreparation
SST
Disassembly / Assembly
1. Disassemble in the order shown in the figure, referring to Disassembly note.
2. Assemble in the reverse order of disassembly, referring to Assembly procedure.
Output Gear:
Disassembly note
Bearings
Remove the bearings from the output gear by using the SSTs.
Assembly procedure
Bearings
Press the new bearings onto the output gear by using the SSTs.
Seal rings
Note: Do not damage the seal ring when installing it.
Apply ATF to new seal rings and install them to each side of the output gear.
Seal ring inner diameter: 27.6 mm (1.087 in)