Throttle Pressure Test

Procedure:

This test measures throttle pressures as a means of checking the hydraulic components and inspecting for oil leakage.

Preparation
1. Perform the preparation procedure outlined in STALL TEST.
Stall Test
2. Connect the SST to the line pressure inspection port (square-head T plug).

Procedure
1. Start the engine.
2. Check the idle speed in P range.

Idle speed: 700 - 800 rpm (with parking brake applied)

3. Shift the selector lever to D range and read the throttle pressure at idle.

CAUTION: Perform steps 4 and 5 within 5 seconds to prevent possible transaxle damage.

4. Depress the brake pedal firmly with the left foot and gradually depress the accelerator pedal with the right fool
5. Read the throttle pressure as soon as the engine speed becomes constant, and release the accelerator pedal

CAUTION: Idling for at least one (1) minute cools the ATF and prevents its deterioration.

6. Shift the selector lever to N range and run the engine at idle for at least one (1) minute.

Specified throttle pressure:





7. Install a new square head plug in the inspection port.
Tightening torque: 5.0 - 9.8 N.m [50 - 100 kg.cm, 44 - 86.8 in.lbf]

Evaluation Of Throttle Pressure Test

Evaluation Of Throttle Pressure Test: