Selector Lever

Fig. 3 Selector Lever Adjustment:

1. Move gearshift lever to P position.
2. Loosen locknuts A and B, Fig. 3.
3. Shift transmission to P position by moving selector lever on transmission.
4. Using a feeler gauge, adjust gap between adjust lever and locknut A to 0.039 inch (1 mm), then remove gauge and torque locknuts to 69 - 95 in.lb.
5. Move selector lever to N, D and P ranges and ensure there is clearance between select lever bracket and guide pin.
6. If clearance is not satisfactory, readjust locknuts.