Hold Indicator

Inspection




Operation
1. Turn the ignition switch ON.
2. Press the hold switch ON/OFF and verify that the hold indicator illuminates when the hold mode is selected.

NOTE: If a malfunction occurs in the EC-AT system, the hold indicator flashes.

3. If not as specified, inspect the combination meter and/or hold switch.

Continuity
1. Disconnect the negative battery cable.
2. Remove the combination meter.







3. Check continuity between terminals 2H and 4M of the
4. If not correct, replace the bulb or the combination meter.
5. Install the combination meter.
6. Connect the negative battery cable.