Lower Valve Body

Disassembly / Inspection / Assembly

CAUTION:
- Each valve should slide out by its own weight.
- When a valve will not slide out by its own weight, depending on the valve, push it out with a wire or place the valve body open-side down and lightly tap it with a plastic hammer. Never scratch or otherwise damage the valve surface or bore.
- Do not drop or lose the valves or internal parts.
- Do not use a magnet to remove or Install parts.

1. Disassemble in the order shown in the figure, referring to Disassembly Note.
2. Inspect all parts and replace as necessary.
3. Assemble in the reverse order of disassembly. referring to Assembly Procedure.

Inspection

Springs




1. Measure the spring free length.
2. If not within specification, replace the spring.

Specification:

Specification

Assembly procedure

CAUTION:
- Before assembly, make sure all parts are thoroughly cleaned.
- Apply ATF to all parts and bores.
- NOTE the proper direction of the valve and internal parts.
- Do not reuse any parts that have been dropped.
- Do not scratch the valve or valve body.
- Wrap a screwdriver or rod with tape before using it to insert a valve.




1. Insert the servo charger spring, valve, and plug.
2. Insert the stopper pin while pushing the plug.




3. Insert the steel ball and 3-2 timing valve.
4. Insert the retainer.




5. Insert theist reducing valve and spring.
6. Insert the retainer while compressing the spring.




7. Insert the modifier accumulator valve, spring, and plug.
8. Insert the stopper pin while pushing the plug.

Steel Ball Installation Positions:

Bracket Installation Positions:

Bolt And Nut Installation Positions:

Installation Positions