Maintenance

Inspection

Level

CAUTION: Place the vehicle on a flat, level surface.




1. Apply the parking brake and securely position wheel chocks to prevent the vehicle from rolling.
2. Warm up the engine until the ATF temperature reaches 60 - 70 °C (140 - 158 °F).




3. While depressing the brake pedal, shift the selector lever to each range (P-L).Leave it a few seconds in each range.
4. Shift back to P range.






NOTE: Use the cool (20 °C) range only as a reference.

5. Ensure that the ATF level is in the hot (65 °C) range. Add ATF to specification, if necessary.

ATF Type: Dexron (R) II or M-III
Capacity: 8.6 liters (9.1 US qt, 7.6 Imp qt)




Condition

NOTE:
- Observe the condition of the ATF carefully, and determine whether or not the automatic transmission should be disassembled.
- If the ATF is muddy and varnished, it indicates burned drive plates and/or brake band.

1. Check the ATF for discoloration.
2. Check the ATF for any unusual smell.




Fluid leakage
Check for ATF leakage at the points shown and repair or replace as necessary.