Control Valve Body (on-Vehicle Removal/Installation)

SST:

Preparation

On-vehicle Removal

CAUTION: Clean the transaxle exterior thoroughly with a steam cleaner or cleaning solvent before removal.




1. Support the engine by using the SST.
2. Jack up the vehicle and support it with safety stands.
3. Drain the ATF into a suitable container.




4. Remove the engine mounting member.




5. Remove the oil pan and gasket.




6. Disconnect the connectors and remove the control valve body.

On-vehicle Installation




1. Install the control valve body and wiring clips as shown.

Tightening torque: 7.9 - 10.7 N.m (80 - 110 kg.cm, 70 - 95.4 in.lb)

2. Connect the connectors.
3. Apply a thin coat of silicone sealant to both sides of a new gasket.
4. Install the new gasket and the oil pan.

Tightening torque: 8.4 - 10.7 N.m (80 - 110 kg.cm, 70 - 95.4 in.lb)

Bolt length (measured from below the head)
(A) :30 mm (1.18 in)
(B) :50 mm (1.97 in)




5. Loosely install nuts A.
6. Install the engine mounting member.

Tightening torque
Nut (A) : 38 - 51 N.m (3.8 - 5.3 kg.m, 28 - 38 ft.lb)
Bolt (B) : 64 - 89 N.m (6.5 - 9.1 kg.m, 48 - 65 ft.lb)

7. Remove the SST from the engine.
8. Pour in ATF and, with the engine idling, check the ATF level and check for leaks. Service and Repair
9. Drive the vehicle and check the shift points, shift schedule, and shift shock. Road Test