Torque Converter

The torque converter is a welded unit and cannot be disassembled.




Inspection
1. Inspect the outer surface of the torque converter for damage or cracks, and replace it if necessary.
2. Inspect for rust on the pilot hub of the torque converter or on the boss. If there is any, remove the rust completely.
3. Measure the bushing of the torque converter boss. Replace the converter assembly if the bushing is worn.

Bushing inner diameter
Standard: 53.030 mm (2.088 in)
Maximum: 53.076 mm (2.090 in)




Washing inside of torque converter
1. Drain any ATF remaining in the torque converter.
2. Pour in solvent (approx. 0.50 liter (0.53 US qt, 0.44 Imp qt)).
3. Shake the torque converter to clean the Inside. Pour out the solvent.
4. Pour in ATF.
5. Shake the torque converter to clean the inside. Pour out the ATF.