Hold Switch

Inspection




Inspection of operation
1. Turn the ignition from switch OFF to ON.
2. Verify that the HOLD indicator is not illuminated. Depress the hold switch and verify that the HOLD indicator comes ON.
3. If not as specified, check the terminal voltage of the hold switch.

Inspection of voltage
1. Remove the rear console.
2. Turn the ignition switch ON.







3. Check the voltage at the hold switch connector.
4. If not as specified, check the continuity of the hold switch.

Inspection of continuity
1. Disconnect the negative battery cable.
2. Disconnect the hold switch connector.







3. Check continuity of the switch.
4. If not as specified, replace the selector lever knob assembly.
5. Install the rear console.
6. Connect the negative battery cable.




Replacement
1. Remove the rear console.
2. Disconnect the connector and remove the hold switch terminals.
3. Remove the selector lever knob assembly.
4. Install a new selector lever knob assembly.

Tightening torque: 2.0 - 2.9 N.m (20 - 30 kg.cm, 17 - 26 in.lb)

5. Install the hold switch terminals and connect the connector.
6. Install the rear console.