Attachment II - Procedure
ATTACHMENT IIA. VEHICLE INSPECTION PROCEDURE
1. Verify that the vehicle is within the following ranges:
^ 1993-1997 626 VIN Range: 1 YVGE22***5102626 - 682122
^ 1993-1997 626 Build Date Range: March 23, 1992 - June 26, 1997
^ 1993-1997 MX-6 VIN Range: 1 YVGE31***5100202 - 673418
^ 1993-1997 MX-6 Build Date Range: February 24, 1992 - May 30, 1997
- If the vehicle is within the above range, proceed to step 2.
- If the vehicle is not within the above range, return the vehicle to the customer or inventory.
2. Perform a Vehicle Status Inquiry using your MDCS System and inspect vehicle for an Authorized Modification Label SSP 55 attached to the driver's door. Refer to illustration.
NOTE:
Be sure to verify SSP number as the vehicle may have multiple SSPs.
- If MDCS displays SSP 55 N and an Authorized Modification Label is not present, the SSP has not been performed. Proceed to "B. REPAIR PROCEDURE".
- If MDCS displays SSP 55 N and an Authorized Modification Label is present, contact the Warranty Department. They will update the vehicle warranty.
- If MDCS displays SSP 55 D and an Authorized Modification Label is not present, proceed to "C. AUTHORIZED MODIFICATION LABEL INSTALLATION".
- If MDCS displays SSP 55 D and an Authorized Modification Label is present, the SSP has already been completed. Return the vehicle to the customer or inventory.
- If MDCS does not display SSP 55 N or SSP 55 D, this SSP does not apply to the vehicle. Return vehicle to the customer or inventory.
B. REPAIR PROCEDURE
1. Remove both front wheels.
2. Insert the bottom portion of guard bracket (B) into the slot between the damper and the knuckle as shown.
NOTE:
Guard bracket assemblies are identical for left and right side.
3. Position the guard bracket (A) to the damper and align the bolt holes with guard bracket (B).
4. Install the two bolts, each with tightening torque of 28.8 - 36.0 ft-lbs (39.2 - 49 Nm, 4.0 - 5.0 kgf m)
5. Install guard assembly on the other side of vehicle.
6. Reinstall both front wheels and torque the nuts to 65 - 86 ft-lbs (89.0 - 117.0 Nm, 9.0 - 12.0 kgf m).
C. AUTHORIZED MODIFICATION LABEL INSTALLATION
Complete an "Authorized Modification Label" with the SSP number written on the sticker and affix it to the driver's door. Refer back to the illustration under "A. VEHICLE INSPECTION PROCEDURE".