Line Pressure Test

PROCEDURE
1. Start the engine.
2. Shift the selector lever to D range and read the line pressure at idle.
3. Connect the SST (49 B019 902) to the line pressure inspection port.

CAUTION: If the accelerator pedal is pressed for longer than 5 seconds while the brake pedal is pressed, the transaxle could be damaged. Therefore, do step 5 and 6 within 5 seconds of each other.

WARNING: Slight variations in line pressure data are due to changes in ATF temperature, which are brought about by line pressure control. The following line pressure data is for ATF temperature of 80°C (176°F).

4. Depress the brake pedal firmly with the left foot and gradually depress the accelerator pedal with the right foot.
5. Read the line pressure as soon as the engine speed becomes constant, then release the accelerator pedal.
6. Shift the selector to N position and let the engine at idle for 1 minute or more to cool the ATF.





7. Read the line pressure at idle and at the engine stall speed for each range in the same manner.
8. Install a new square head plug in the inspection port and tighten to 5.0 - 9.8 Nm (44 - 86.7 inch lbs.)