Shift Mechanism

1. Disassemble in the order shown in the image.
2. Inspect all parts and repair or replace as necessary.
3. Assemble in the reverse order of disassembly, referring to Assembly Note.




1. Shift lever knob
2. Front console
3. Insulator
4. Transverse member
5. Exhaust pipe
6. Nut
7. Bolt
8. Nut
9. Bolt
10. Change control rod Inspect for bending
11. Bushing
12. Bushing
13. Nut
14. Washer
15. Washer
16. Nuts (base plate)
17. Assist boot
18. Mounting rubber boot
19. Retaining ring
20. O-ring
21. Ball seat (upper)
22. Boot
23. Ball seat (lower)
24. Gear shift lever
25. Pipe
26. Bushing
27. Extension bar
28. Nut
29. Bolt
30. Rubber mount
31. Base plate




Assembly Note
Nuts (base plate)
1. Install the base plate to the floor. Then install the extension bar onto the transaxle.

Tightening torque: 38-51 N.m (3.8-5.3 kgf.m, 28-38 ft.lbf)

2. Tighten the nuts (base plate) to the specified torque.

Tightening torque: 9.81-14.7 N.m (100-150 kgf.cm, 86.8-130 in.lbf)