Manual Trans.
Preparation1. Warm up the engine to normal operating temperature.
2. Shift the selector lever to Neutral.
3. Turn OFF all electric loads.
^ Headlight
^ Blower
^ Rear window defroster
^ Power steering
4. Wait until the coolant fan has stopped.
Idle Speed Adjustment
1. Perform Preparation. (Refer to above.)
2. Connect a tachometer to the data link connector terminal IG- as shown.
3. Verify that the idle speed is within specification.
Idle speed (Neutral): 650-750 (700 ± 50) rpm
4. If not within specification, connect the SST to the data link connector.
5. Set switch A to position 1.
6. Set the test switch to SELF TEST.
7. If the SST is not used, connect a jumper wire between the TEN terminal and the GND terminal of the data link connector.
8. Adjust the idle speed by turning the air adjusting screw.
Idle speed (Ground the terminal TEN): 650-750 (700 ± 50) rpm
9. Disconnect the SST.