Clearing Diagnostic Trouble Codes (DTCs)

Caution: Do not attempt to pry off connectors with a screwdriver. This will damage the connector and could result In a transaxle concern.






1. Disconnect transaxle tester from the solenoid body connector and TSS connector.
2. Reinstall emission harnesses. Verify connection by pulling up on the harness.






3. Disconnect transaxle tester power lead from vehicle.
4. Erase all DTCs resulting from continuous test using the precedures in Computers and Control Systems.






5. Rerun On-Board Diagnostic Test to receive a pass code (111).
6. Based on transmission tester testing results, proceed to the appropriate segment of this section for transmission or electrical/wiring service.
7. Confirm service by repeating transmission tester test.